|
Jump
Frame |
|
> |
Measure existing frame by determining the innermost
edge of metal frame and build window accordingly
(width x height). |
|
> |
Remove glass and any mullions thus creating a clear
unobstructed opening. |
|
> |
Ensure the front face of existing frame is clean. |
|
> |
Apply a generous bead of sealant to front face of
existing metal frame, additionally apply a generous
bead of sealant to backside of new window should the
window make contact with existing finish of home. |
|
> |
Install new window into opening by pulling from the
outside in, thus creating a leak free installation. |
|
> |
Fasten new window with screws in pre-determined
locations of jamb to the existing frame. |
|
> |
Install insulation between new window frame and
existing frame and thus creating a thermal break. |
|
> |
Install a primed wood trim around the perimeter of
inside window opening to "marry" the new window to
the existing frame. |
|
> |
Apply sealant to interior wood trim and new vinyl
window. |
|
> |
Fill all nail holes to wood trim, making it paint
ready. |
|
> |
Check exterior of window to ensure a positive and
clean seal has been acquired. |
|
> |
Window is installed. |
|
Full Frame
Out |
|
> |
Measure opening from jamb to jamb and sill to top
jamb of existing opening and have window built to
these sets of measurements (width x height) |
|
> |
Cut
around perimeter of existing window nail in flange
which is usually 1 1/2 inches bigger than the
visible window around. |
|
> |
Once
flange had been exposed, remove nails that fasten
the window to the exterior of home. |
|
> |
Once
nails have been removed the existing window is
removed. |
|
> |
Upon
removal of window a water resistant material (tar
paper) is stapled to the sheathing to reseal the
building envelope. |
|
> |
A
primed exterior comb-face material is installed to
create a clean and consistent surface for the new
window to be sealed. |
|
> |
Apply a
liberal bead of sealant to the back side of the new
window flange. |
|
> |
Place
new window into new opening from outside to the
inside. Ensure a positive seal has been acquired. |
|
> |
Fasten
window at inside of new window jamb at
pre-determined locations with 2 1/2 inch screws. |
|
> |
If
window is in an exposed area a metal window flashing
is installed at top of window further ensuring a
leak free installation. |
|
> |
A clean
bead of paintable caulking is then applied to the
interior of new window where it joins the existing
window jambs and sill. |
|
> |
Window is installed. |
